Technical specifications
Power supply: 230V AC ~ 50Hz
Operational temperature: 0°C to 40°C
Dimension: diameter 90mm without flange, 120mm with flange, height 45mm, without relay switch
Protection rating: IP20
Weight: 45g without flange / 60g with flange, without relay switch
Warranty: 2 years
Installation
1/ Cut the power supply.
2/ Insert the relay switch into its DCL
3/ Screw in the 6 screws of the relay switch
4/ Assemble 120mm flange if required,
Caution: in this case a 110 mm piton is required.
5/ Connect the power supply to the terminal block provided
6/ Screw the python to close the assembly
7/ Turn the power supply back ON
Use and pairing
An action on the button of the DCL corresponds to an action on the wire switch connected to the module.
Use
You can use the button on the DCL to start pairing your module (see section “Pairing”).
Pairing
EnOcean
If you have an EnOcean module, press the button on the DCL to start the pairing procedure..
Zigbee
If you have a Zigbee module, it will be paired for 15 minutes after it is powered up. After 15 minutes, press the button on the DCL to restart the pairing procedure.
Technical contact
Do you have a specific question or need help with the installation or use of your product? Contact us here