Prerequisite products
Installation of the relay switch
Wiring diagrams
On a CMV
Installation at the electrical panel - NodOn DIN Rail Box is needed
Appairage des produits
To pair the opening sensor to the relay switch, you must enter into pairing mode. The module has to be under power supply.
1.Launch the pairing by doing 3 consecutive presses on the button of the module. The LED blinks in red.
2. You have 30 seconds to press the button at the back of your opening sensor. The position (close or far) of the magnet from the sensor will define the relay switch state (see table below).
3. The relay switch LED becomes green, confirming the pairing of the two devices.
Technical support
You have a specific question or need help regarding the installation or use of your product? Contact us by email at rf.no1734953498don@t1734953498roppu1734953498s1734953498 or at +33 7 68 04 20 90.