• User guide

Wiring diagrams

The repeater mode is requisite if two devices of the installation are 30 meters far away one from another.

The activation of the repeater mode has to be made with the module under power supply.

When the repeater mode is activated, the ON/OFF Lighting Relay Switch will repeat all the messages from EnOcean network, and so increase the range of the devices around it.

The repeater mode has 3 levels:

• Level 0: repeater mode is deactivated
• Level 1: the signal is repeated (1 jump, see figure 1)
• Level 2: the signal is repeated (2 jumps, see figure 1)

Warning: by default during the first installation the repeater mode is at level 0.

Incrementation of the three levels for repeater mode:

Repeater mode working principle (figure 1):

Access to repeater’s next level:

Level 0 to level 1:

1. Do 2 short presses.
2. The module LED blinks twice in green, confirming the activation of repeater’s next level

Level 1 to level 2:

1. Do 2 short presses.
2. The module LED blinks three times in green, confirming the activation of repeater’s next level.

Level 2 to level 0 (repeater mode is deactivated):

1. Do 2 short presses.
2. The module LED blinks once in green, confirming the repeater’s mode deactivation.

Devices pairing

To pair your controller with each of the modules installed, see the picture below. To pair a controller, please refer to the ON/OFF Lighting Relay Switch user guide.

You have a specific question or need help regarding the installation or use of your product? Contact us by email at rf.no1734848309don@t1734848309roppu1734848309s1734848309 or at +33 7 68 04 20 90.